Instructions for replacing the push-up drain

Two people are recommended to handle this procedure the easiest and fastest. It does not require any experience or similar expertise when these instructions are followed.

1. Remove the old drainage hose and push-up valve, cut the hose and leave approximately 7cm:

    

   

    

2. Sand the plastic material around the hole for the drain before applying silicone there.

    

   

    

3. Apply silicone to the threads of the upper connection part and lubricate the threads. This is to seal so it cannot leak through the threads.

    

   

    

4. The upper part (1) with the white plate is placed in the hole and one person handles the hose with the white plate (2) and the drain part and places it under the barrel to the place where the connection part is located.

    

   

    

5. Adjust both parts so that the upper part can be screwed down into the lower one. First by hand and then use 2 washers and a screwdriver to be able to tighten a little harder.
   :