The traditional round hot tub can also be equipped with TubCoat sides and base. The sides are then made in modules, either 6 or 8, depending on whether the diameter is 150 cm (HT 150) or 180 cm (HT 180) and it provides a durable elastic surface that is easy to keep clean. Joint sealer is added between each side stave and base plank before it is machined and coated It keeps the module together and makes it easy to clean. The base is made in 3 parts and made in similar way.
The inner diameter is either 150 cm (6 benches) or 180 cm (8 benches). The amount of water is then 1200 litres or 1800 litres. Quick and easy assembly, that nonetheless require carefull attention to detail and that the accompanying directions are followed. All parts are fully prepared. The only extras needed are a rubber mallet, screwdriver, spanner or similar.
The assembly of the ready-made modules is fast and easy. For joining all the modules together, a special joint sealer is used, which is also included in the kit. The hot tub is tightened together with stainless steel bands, in the same way as the Basic models. The standard kit includes, in addition to the things mentioned earlier, benches, an edge, a wood-burning heater with connections depending on your chosen method of heating.
A draining tap is connected to the lower circulation pipe that is located under the base. If the drainage needs to be taken further away, it is possible to extend it with a 32 mm hose. The lid, stairs, bubble and filtration system, and underwater lighting are also optional extras.