The SD6200 is a complete electronic control system with WiFi module that makes it possible to also monitor and control the water temperature via, for example, a smartphone. Manual control via the control is another option. The control system is developed from extensive experience with spa products and with a focus on simplicity and ease of use.
The control system has a built-in timer function and when the power is switched on the water pump will automatically run for 2 hours and then stand still for 6 hours and work like this in cycles around the clock. Filtration then also takes place as well as heating if the temperature is lower than 2 degrees below the set target temperature. In normal operating mode, the set water temperature is reached during the time cycles,
If the water is to be heated from a low temperature (for example after a water change), the automation takes care of it via the function "Heating mode for cold water".
When renting, it is most appropriate to use the "Temperature control" function, which means that when the temperature is 2 °C below the set temperature, the water pump starts and the heater turns on until the temperature reaches the set value. Otherwise, everything else also works, such as filtration cycles "2 hours on and 6 hours off" when the temperature has been reached.